Contents - Index


Secondary Toolbar

The secondary toolbar is located just below the main toolbar along the top edge of the application.

Buttons

  File New - Brings up the File Management dialog box

  File Open - Open one or more existing WAV files using the File Management dialog box 

  File Save - Save the current WAV files

  Print - Print the active plot (time series, spectrum, phase, spectrogram, or 3-D surface)

  I/O Device Settings - Brings up the Input Device dialog box

  FFT Settings - Brings up the FFT settings dialog box

  Scaling - Brings up the Scaling options dialog box

  Calibration - Brings up the Calibration dialog box

  Triggering - Brings up the Triggering options dialog box

  Run Control - Brings up the Run Control options dialog box

  Select Single Channel Plots - brings up the Plot Selection dialog box

  Select Composite Channel Plots - brings up the Composite Plot selection and configuration dialog box

  Signal Generator - open/close the signal generator

  Hz - open/close the Peak Frequency utility

  dB - open/close the Peak Amplitude utility

  Pwr - open/close the Wideband Level (total power) utility

  THD - open/close the Total Harmonic Distortion utility

  THD+N - open/close the Total Harmonic Distortion + Noise utility

  THD+N vs Freq - open/close the THD+N vs Frequency utility

  IMD - open/close the InterModulation Distortion utility

  SNR - open/close the Signal to Noise Ratio utility

  Leq - open/close the Equivalent Noise Level (Leq) utility

  Log - open/close the Data Logging options

  Rvb - open/close the Reverberation Time utility


See AlsoMain Toolbar, Plot Toolbars