Contents
- Index
Secondary Toolbar
The secondary toolbar is located just below the main toolbar menu along the top edge of the application.
Buttons
File New - Close any open WAV file and prepare to record a new one
File Open - Open an existing WAV file
File Save - Save the current WAV file
Print - Print the active plot (time series, spectrum, phase, spectrogram, or 3-D surface)
Time Series View - open/close the time series plot
Spectrum View - open/close the spectrum plot
Phase View - open/close the phase plot
Spectrogram View - open/close the spectrogram plot
3-D Surface View - open/close the 3-D Surface plot
FFT Settings - Brings up the FFT settings dialog box
Scaling - Brings up the Scaling options dialog box
Calibration - Brings up the Calibration dialog box
Triggering - Brings up the Triggering options dialog box
Run Control - Brings up the Run Control options dialog box
I/O Device - Brings up the Device Settings dialog box
Signal Generator - open/close the signal generator
Hz - open/close the Peak Frequency utility
dB - open/close the Peak Amplitude utility
Pwr - open/close the Wideband Level (total power) utility
THD - open/close the Total Harmonic Distortion utility
THD+N - open/close the Total Harmonic Distortion + Noise utility
THD+N vs Freq - open/close the THD+N vs Frequency utility
IMD - open/close the InterModulation Distortion utility
SNR - open/close the Signal to Noise Ratio utility
Leq - open/close the Equivalent Noise Level (Leq) utility
Mac - open/close the Macro Command Processor utility
Log - open/close the Data Logging utility
Alerts - open/close the Alerts utility
Dly - open/close the Delay Finder
Rvb - open/close the Reverberation Time utility
Scp - open/close the Stereo Phase Scope
Note: Use the <View><Toolbars><Secondary Toolbar> to show or hide the toolbar.